The HP Tuners H-002-02 lengthens the reach between an HP Tuners interface and the vehicle OBD-2 port when the factory diagnostic connector sits somewhere awkward to work around, such as behind trim panels or deep in the dash. Adding 5 ft. of cable between the interface and the vehicle connector lets a tuner position the programmer conveniently on the seat or dash without straining the original connection.

HP Tuners H-002-02 Technical Specifications:

• Extends the OBD-2 connection by 5 ft., giving extra reach between the interface and the vehicle diagnostic port.
• Uses a standard OBD-2 connector on both ends for a direct pass-through fit with no adapters required.
• Works with the full range of HP Tuners MPVI-series interfaces that use a standard OBD-2 connector.

Emissions Disclaimer

HP Tuners designs and manufactures software and hardware tools for vehicle diagnostics, scanning, logging, calibration, and data acquisition purposes. The authorized use of such tools is to bring a motor vehicle into emissions compliance and/or to maintain emissions compliance, as well as for use on competition/racing and other exempted vehicles. HP Tuners does not create or provide tunes or pre-made calibrations.

HP Tuners' Terms of Use, policies, and agreements mandate that users shall comply with all local, state, and federal laws. In using HP Tuners software and hardware tools, you are representing, warranting, and agreeing not to use, employ or allow any HP Tuners tools to operate as a defeat device or to violate emissions compliance in any manner whatsoever. You further represent warrant and agree that the HP Tuners tools shall only be used by manufacturers, calibration businesses, and professionals to develop emissions-compliant and/or exempted calibrations.

Emissions Note:

This part is only legal for sale and use on Uncontrolled (Non-Emissions Controlled) Vehicles or on vehicles used solely for the purposes of closed competition racing.

CLICK THIS LINK FOR IMPORTANT CARB & EPA EMISSIONS INFORMATION ABOUT THIS PART